Stuff for sale at the Valley Hybrids Stockton Swap Meet

[Fast Eddy]

Location

United States

I'll start with stuff I'm not bringing unless it's for sure going to sell:

'76 Hard Top - $500
2f Crank - $100 obo
h42 & matching case - $250 mostly complete minus e-brake parts (price drop again)
another h42 trans only - $75obo (price drop)
transfer case, no covers, a few gears, rear section of output shaft - $50obo
Other 2f parts: oil pump, oil cooler, timing and side covers, bearing caps...
2f Iskenderian-ground performance camshaft
Stock leaf springs

Stuff I'm bringing:

FJ60 SOA front housing, C&T by Proffitt's, $300obo (sold)
4x4labs High Steer for an FJ60: nearly new, $300obo (orangefj45 has dibs)
Proffitt's outboard spring mounting brackets
Aftermarket shoulder belts for a 76+ fj40 $50 (sold)
Nice set of four Center Line 15x7 brushed aluminum rims with smaller holes (the style, not the centers).

Ton's of small parts - See my FS thread below.

Stuff I need:
Barn Door latch hook (got one)
Amby door handle rubber cover
Set of 6 footman loops that mount to body, especially the two curved ones
Nice used '75+ tail light lenses
e-brake parts

 

[In2cruisers]

Interested in hard top...pics please

also interested in shoulder belts $ ??

 

[orangefj45]

is the high steer kit complete, arms, drag link and tie rod as well as ends?

very interested!

i have a bunch of ebrake parts.....

georg

 

[zebrabeefj40]

FYI - The tail light lenses are about $13 each new from Toyota. I just bought a couple from CDan a couple months ago.

Nick

 

[davegonz]

How much for the aftermarket FJ40 shoulder belts?? I'm interested.

 

[Pighead]

Good idea Eddie...I'll be there with my usual Pig-load of stuff, but, I also have an engine hoist and engine stand, both from Napa, good quality, that will handle a 2F.
I don't see me needing one for a few years and I'm tired of paying storage. Lend/lease options also considered. Also have the "leveler" gizmo that goes between the hoist and the block that makes stabbing the engine that much easier.

 

[Fast Eddy]

is the high steer kit complete, arms, drag link and tie rod as well as ends?

very interested!

I'll put your name on it. It's complete and still together. From what I see, if you're interested at all, you'll want it. Schmukster said it was only run on the trail a few times. Other than minor surface rust it's obviously almost new and currently stored inside. I'll send a couple pictures.

The drag link has an extra outer sleeve welded to it. I'm sure you could jack up the whole truck off the drag link without any deflection.

 

[Fast Eddy]

FYI - The tail light lenses are about $13 each new from Toyota. I just bought a couple from CDan a couple months ago.

Ok, buy some new ones and I'll buy your old ones. I don't want them to look new. My rig is old.

 

[Fast Eddy]

Buummmmpppppp.

 

[vipergrhd]

stuff for sale

Fast Eddy said i could post stuff here for the Stockton swap meet here are some of the stuff i'm bringing (hope to make it) to the meet.

Rear OME medium springs only $300
Rear diff. housing only (case) $100
5 point seat harness (red) $200
rear 3rd member only complete (2) $100 each
front 3rd member only complete $100

I got other stuff that i need to look up but this is the heavy stuff that needs to go. swnd me a PM if interested.

John

 

[flshrcr]

What is the date of the swap meet ?..................rod

 

[autokalikot]

date and address of the incoming swapmeet?

Thanks.

 

[splib]

April 2nd.

https://forum.ih8mud.com/trails-events-expeditions/454967-cruiser-swapmeet-2011-stockton-ca.html

 

[autokalikot]

Thanks for the info. Too bad, I'm out of the country. I surely missed.

 

[55guy]

Looking forward 2cu cruiserheads

I"ll bring a fj55 tail gate ? very good condition $100 ?????
1966Fj 45lv $7,500
look me up !!

 

[Flatty]

FJ40 gauge cluster
Rear foldup door (for the top)
Gas Tank
heater assembly (everything)
bucket seats from a 80's race car (not jaz, but padded race seats)
fender skirts
full set of 33" tires with wheels (old school vintage 90's)

Got more stuff. will update as I find more things
Dima

 

[poor boy pulling]

i take it this is the thread to post stuff you have and can bring or plan on bringing? if so some of the stuff i have some of which will only bring if i have a buyer
for fj55
window regulators
driver front door good shape
driver rear door dented but usable
tail light lenses
stock hubcaps

fj40 parts
4 speed tranny great shape
AA bellhousing from SBC to 4 speed cruiser tranny great shape
AA propeller mount great shape
3.73 R&P fine spline good used
76 (1f?) complete engine with bell housing (need to have pre sold to bring) suppose 60k on rebuild
just to name some

 

[vipergrhd]

in addition

to the list that i had on an earlier post,this is for an fj 60.

Grey dash pad has some cracks willing to take offers.
Gray front door panels with arm rest in excellent condition
Gray oem center console in good condition
Center panel trim bezel no cracks good condition
factory side mirrors left in good conditoin right side could used a new mirror.
Rear sway bar only from fj62 some rust issue.



Thats it for now unless i dig out some other stuff. John

 

[Brass]

Howdy y'all!

The timing and location could not be better. I just bought a 1973 FJ40 and this swap meet is practically right down the street from me. Looking forward to seeing more cruisers and meeting the owners.

I'm finding that these vehicles are a little like Mr. Potato Head, choose the parts to get it your way.

Here's mine.

 

[ToyotaDon]

Bringing a few things I've collected over the years.

Spark plugs (I think for a 3FE)

Some wheel cylinder rebuild/seal kits.

Miscellaneous 80-series stock parts, and even a J**p Wrangler speaker bar.

There's some other electronic junk that some might be interested in, and some old Toyota reference manuals.
Hopefully it doesn't get to be too much like a yard sale.