Recent content by Willis

I used 1/8th NPT, but it's up to you what tap you prefer to use. They will all work fine.

Text me, I probably have one 5414200049

Performed a 1HDFT motor swap on a 1986 BJ70, using an OEM HZJXX wiring harness. So I am searching for a very specific cluster - Rear pinout must look like this (3 slots) and have come from a 1HZ (or perhaps 1HDFTE) 70 series. If it has locker lights, that's an added bonus. But that's a...

Have any pics of the damage? Shame to scrap it because of some fiberglass damage... This is a deal either way

The dust in the exhaust ports do not help your case :D

Both H151 are sold. All flywheels are gone, sorry. I still have an H55f and T-case for a 2F, 3F etc that needs a rebuild. $500 I still have a good used H55f from a 3B motor - 3B, 13BT, etc. $2500 for trans and Tcase

Bump - wads of new photos on the website https://www.thefitgarage.com/hzj75-troopy-alucab

Amazing work as always!

My order from April was delivered yesterday. I hope Matt has figured out whatever he was going through!

That response was wrote by lazy corporate bot of choice: chatgtp 🤖

Did bro just use ChatGTP to write his response? 😂 Love the subtitles

Bump

It's currently at the detailers. Hopefully in a few days I get it back and can get a ton of photos!

1993 HZJ75 Toyota Landcruiser Troop Carrier - Australia import. $75,000 1HD-T Engine - this motor was swapped by Fit Garage in 2023. It was compression tested at 460-470+ per cylinder before install. It was gone through with bottom end bearings, seals, gaskets, rebuilt injection pump...

I have ascertained from this thread, yes. This was for posterity, in case he ever checks :rofl: