Besides removing the covers on the valve actuators directly next to each globe, I didn't run into any problems on my end. 2nd person made it easier. Just watch the lines as you bring it up. I believe 1 nut was tricky to reach, forgot which side. This was done on a cold garage floor in the middle...
I noticed when I replaced the front two height sensors, This shortened the time drastically. Not sure what happened but im back to having slightly long times again. I did notice that its not as long as it was before I replaced the front sensors. Im going to replace the rear sensor to see if that...
Try placing the keg inside, cycle through all heights, drop it to low, remove keg, close all doors and give it a few seconds before bringing it back up to Normal height. If its still there there could be other problems. Another idea is to slightly raise the rear height sensor to pump more fluid...
2006 LX470 Front Diff/3rd Assembly ~ 250k miles on unit.
Want to build your front diff but can't afford the downtime? This blown example below is for sale. Everything pictured related to the diff is included. Would prefer local pickup to Northern Virginia. Can travel further out for a small fee...