Recent content by Pdx13

Turns out I need to replace the unit, not just the harness. Am returning for replacement. Just happy I bothered to read more carefully and figure out I ordered the wrong unit prior to attempting install.

Will be happy to.

Just contacted them and they said a replacement harness ($100) will be sent. Once again my failure to carefully read the details has cost me. Guess I should be happy that I realized it prior to installation. Thanks for the prompt reply. Will report on how it works when installed.

I recently purchased the EC unit for my 2018 LC, and failed to notice there are different units for trucks manufactured before and after July 2018. My truck was manufactured in June 2018, and I purchased the post July 2018 unit. Wondering if, besides wasting the extra $, is this unit not going...

Any rust? Undercarriage photos?

my new wheels have no center caps and I actually prefer the look.

Not sure about fit on the 470. They are 5x150 lug pattern.

Switched to 17’s so I have the original 18” alloys and Dunlops for sale. Tires are 285/60R Dunlop Grandtreks with 10K miles. Wheels are pristine except for a couple of peeling center caps. Pick up in Portland only. $600.

Nicely done. 2012-2015 were good years for Lexus design.

I am waiting for my 17” wheels a d was vacillating between the the II’s and III’s. After reading this and above I am going to pick up the III’s. They run about $250 here for 17x70x285

Thanks. I figured the III’s would be considered an improvement.

Did you look at the AT2’s? I am trying to decide between the two. The II’s are a little less expensive but not enough to matter a whole lot. I have heard great things about the II’s and wonder how much different the III’s are.

It is actually a dark silver used on the engines of older model BMW motorcycles. It is slightly darker than the silver on the grill.