Recent content by Ohashimi

Check this tray out. I've been 3D printing these out of ABS and Rubber and have been using mine for a few months now. I have them posted on Etsy if you guys want to check it out. link to the Etsy below. 98-2003 LX470 or Land Cruiser Center Console Insert tray -May fit other years as well

I did a quick video on how to replace the alternator if anyone is interested.

Great information Thank you Very much for that write up. I will definitely use that procedure next time. I have not run the engine since doing the exchange since i am doing the alternator and radiator at the same time and have to wait for the alternator to arrive today. Thanks again for your...

I had to exchange my fluid because i accidentally used T-IV instead of dexron II or III. Video below

I agree. If were to do it again i would just let it run till it was all pumped out and refill with new. I have already dropped the pan and replaced the mesh filter. although it really didn't need to be replaced.

This is what I did to change my transmission fluid in my lx470 98

Watch this video for how i did the transmission fluid exchange on my lx470 98

If anyone wants to know how to take the side mirror apart and fix the components watch this

not sure if anyone has see this but it really is very helpful and has lot of good information on head unit install as well as sound deadening

I've a few videos on youtube showing how i set up my system using the factory amp at first. then i decided to go with an all new setup with new amp under passenger seat using the existing mounts. Hope this helps some people.

I have a video on how to replace this antenna and also show how I remove the assembly. Might help you guys.

I have a video on how to replace this antenna mast as well as remove the old nylon cord that broke of in the assembly. see link bellow. Hope this helps some of you folks. In the description i added the amazon link i used to get my antenna that looks exactly the same as the OEM one i have a 98 LX470.

HEAVYMETAL is right. you can re-use the washers from the hydraulic shocks. I wish I knew that before doing the conversion. lol. I really wanted to go with the OEM shocks, not just because it's cheaper but i heard it is more comfortable as well. The Bilsteins are pretty firm

yea mine are hanging as well. I guess you could seal them up with some electrical tape to protect them. I'm not planing on ever switching back to AHC so im probably going to just cut the connectors off and leave it alone.

The retaining washers I am referring to are the ones that sandwich the bushings/cushions on the top and bottom of each shock's upper mount. Mine were ruined after i cut the shock off and were rusted but if yours are in good shape then you can re-use them. Yes they are the same part as the land...