Recent content by Njck22

You mentioned it's no fun to drive as a daily, is that only because of the lack of rear weight? I think your build looks absolutely amazing.

I see you followed the instructions for Australia, not northern hemisphere countries. It happens!

Pictures of the undercarriage before the re-spray?

But then the p0430 would be lonely… I would cry

Time for another T-belt!

Any pictures or knowledge of the body condition before the respray? I'm guessing that was done in Oman.

Love the stripes. What size tires?

EFI motors don't excel at extended or deep water crossings. Definitely doable, but I would be more concerned about any of the EFI components getting wet first and leaving you stranded in the stream, before worrying about a little bit of water splashing on your alternator. You will be far from...

No. the vehicle (and you) will explode.

That should be the top pipe in the image I sent. 13 ft lbf

Looks good. 13ft-lbf for intake manifold. I don't see a torque spec for the two coolant temp sensors. Tight enough. snug it up if it leaks.

Is it more of a sound than a feeling? Exhaust heat shield under passenger floor board is my guess if its a sound. Also 100% check motor mounts and trans mounts. Maybe even a harmonic balancer?

bravo on that.

Is there any way to get pre-amp output or digital output from the GROM unit and use our own DAC?

Could it be your license plat slapping the tailgate?