Recent content by Moggul

It is the one mentioned above: KINGBOLEN Ediag Elite OBD2 Scanner Bluetooth, Bidirectional Test Scanner All System Diagnostic Tool I bought it from Aliexpress. Here you have a link: https://www.aliexpress.us/item/3256807921219170.html You can probably get it faster (and more expensive) from...

It does work with my 2000 HDJ100. Granted it shows only limited information but I can get MAP pressure, injection volumes, timing info, AHC pressures and ride height, etc.

I got this kit from Poland and it worked perfectly. https://tafmet.pl/english/en/egr-valve-removal-kits/1049-egr-valve-delete-kit-for-toyota-land-cruizer-100-j1-42-td-hdj100-hdj100-5902553476606.html Insted of just blanking the plate you replace the EGR with the pipe and cover the port in...

I just deleted my EGR valve and the CEL comes on now and then, mostly when the car is cold. I have checked and it is a MAP sensor error but have not diagnosed it yet. Even our cars do not have OBD2 it is still possible to diagnose them. You can get Toyota Techstream installed in an old laptop...

I just got the car from the mecanic and I can report a very happy ending to this situation. Turns out the catalytic converter was badly clogged wich resulted in the engine having difficulties to breathe correctly, which was limiting the power. My mechanic removed all the material from the...

Thank you VADUS. This happened after a very muddy trip so I am suspecting maybe the wastegate is stuck open due to mud. Is there a good way to visually inspect the rod and actuator? I have tried both from above and below the engine but it is buried very deep and I cannot really check it. For...

This happeend to me a few months ago. You need to replace the ignition rod: https://forum.ih8mud.com/threads/ignition-barrel-rod-replacement.1370080/

Thanks for the responses so far. As I understand it, the MAP sensor reads total air pressure in the intake manifold. Therefore, for a turbo engine it should read atmospheric pressure + turbo generated pressure. If the reading is just atmosferic pressure then I assume that turbo boost is zero...

I am experiencing a lack of power in my HDJ100 and I believe the turbo is not generating any pressure as cannot hear it spinning (no whistle). Also I have connected my diagnostic tool and pressure remains under 1 bar at 3k revs. So I have 3 questions. 1. Can Iconfirm that the turbo is not...

I hope these pictures help. Sorry about the metric measurement but this is what we use here ;) 36 cm (14 in) to seat base, 34 cm (13,5 in) to seat handle and 26 cm (10 in) to seat bracket.

Congratulations on your purchase! It definitely looks good... at least from a distance ;) I bought a similar car here in Spain, also the cheapest I could find, and am currently sorting out all the issues that had been overlooked over the years. From your picture I assume you are in the South...

Nothing yet. Car starts and runs wihout issues so far. I am not sure how to measure the parasitic draw so can't confirm but will try to investigate how to do it and report back.

Recently my ignition barrel rod broke an I had to source a replacement. The part number on the broken rod was 7853A. As I could not find that part I purchased part 7853B and got it installed by a competent locksmith. I sourced the part from Tafmet in Poland for less than 20 € + shipping to...

Today I was doing some off-roading with my new to me HDJ100 Automatic and when going down a very deep incline I noticed the engine had cut off power. I did not realice at first because I was only using gravity to go down so but it should be no more than a couple of minutes. For context, I had...

Nice off-roading in central Spain with my bone stock HDJ100.