Alrighty, I made some changes and it's looking pretty good. Anyone know where I can find the exact tolerance spec for knuckle alignment? I think I can realistically get under +-.5mm, but I don't know if that is good enough.
I appreciate all the feedback! A big part of why I am doing this is to get a cheaper (maybe better) tool out there. If it's plastic, I could probably sell it for less than $40 shipped. Stay posted, I will have an updated design to post in a day or two.
I do plan to sell this in some capacity, but I need to validate it a bit. I am a bit worried about other people printing it because printer settings can impact the actual part size once they cool.
Hi all,
I am attempting to design a new tool for aligning the knuckles. The goal is to make something that is a lot cheaper and is more fool proof. Here is a video running through the basic idea. I would love some feedback.
This is great info! can you specify what you mean by "swap an inner axle shaft with your original if using the longer 6x stuff" I have identified a donor fj60 axle for my 1968 fj40. Do I also need to swap the axle shafts from the fj60 housing? Thanks in advance!
Okay... A bit of back story. I have a 1968 fj40, it was my first car and I drove it bone stock for 6 years as my daily driver. Now 13 years into ownership I am starting to make it a bit more usable on a daily basis for me and my fam. I have a front disc conversion on the horizon and fuel...
FREE. Clearing out some old stuff from my parent's garage. I have a Free 1f engine that is mostly taken apart. The engine unfortunately had water sitting in the cylinders before I acquired it so they are rusted. The rest of it has plenty of good parts though. I would love to avoid scrapping it...
okay it might be different for a 64 but on my 68 G is threaded and it threads into the steering column. There is a nut that is cast into the steering column that might just need to be tapped out again.
that spring could be acquired at pretty much any hardware store, it just provides back...
Amazon.com: RCD F4-BE5-6251-H8 5100 Series 46 mm Monotube Shock Absorber for 1965-1982 Toyota Land Cruiser: Automotive
this is what I put on my 68 front and back