3-Speed column shift HELP ????

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 27, 2016
Threads
58
Messages
426
Location
Bakersfield, Ca
After looking at the SOR diagram, I feel like I’m missing parts? On the SOR diagram “B”, what are the (3) small items they are referencing? Not the shaft, but the other (3) items? Am I missing something?

Jason-

91E7F875-569A-4EA1-A30F-10C9FB4182D9.webp


5E8394BF-9E1F-473D-B33F-5F28D381D857.webp
 
And item “G”, this below, one end is threaded, where does that thread into? The hole in the turn signal from Cruiser Solutions is smooth, not threaded? If that’s how it works?

6E848D54-BF6B-428C-A66F-1A0A016A43C3.webp


158876FB-8AA1-4831-AE63-D7A5F42B4C8C.webp
 
Items “B” are the spring and pair of little pins that hold the lever into the column part.

On “G” I don’t know, I haven’t taken mine that far apart yet.
 
So does it appear that I have all the parts? I think I’m missing letter “I”? Is that also a spring?

Jason-
 
The new turn signal housing will need to be tapped to accept the column shift piece.
I should also be a spring.
 
Ok- so I am missing the Spring, lettered “I”. Uggghh, any help where to get that?

B3BAD1A3-B995-432A-85AB-08C0D3FBB95A.webp
 
okay it might be different for a 64 but on my 68 G is threaded and it threads into the steering column. There is a nut that is cast into the steering column that might just need to be tapped out again.

that spring could be acquired at pretty much any hardware store, it just provides back pressure for the shift lever and isn't even necessary to function, so anything that fits and isn't too beefy will work.

hope that helps a little.
 
Ok- so just to clarify before I do this, this part “G”, threads into the turn signal housing at the wheel. I got to thinking about it, possible that it comes smooth and if you have a 3-speed you have to tap it for threads? Either way, we’re all in agreement this needs threads tapped, Correct? :)

2FB4DFBB-21A8-4EFF-ABE0-63A727833C76.webp
 
The housing for the column and floor shift is identicle except the floor shift part has no threads. They had different part numbers but the column shift one is disco and has been subbed to the one you have.

I have had to tap a couple in the past. The metal is hard so use a sharp tap and take your time
 
The housing for the column and floor shift is identicle except the floor shift part has no threads. They had different part numbers but the column shift one is disco and has been subbed to the one you have.

I have had to tap a couple in the past. The metal is hard so use a sharp tap and take your time

Thanks again for the clarification. I’ll be sure to get it done right.

Jason-
 
Back
Top Bottom