Recent content by LX470MN

  1. LX470MN

    Noise upon deceleration... differential problem?

    The main difference is that tire noise would happen in any load condition (accelerating / decelerating / neutral). The noise that I experienced was only audible when accelerating or decelerating. If I applied just a little throttle (to take the load out of the drivetrain) the noise would go away.
  2. LX470MN

    Weird no start issue

    Can you tell me where this part was on your vehicle? Do you have a part number? How did you know it had failed? I'm also trying to resolve an intermittent starting issue with a 2000 LX470.
  3. LX470MN

    Door Lock Actuator Replacement

    Heads up to anyone doing this job; one of the 4 motors I purchased didn't have the collar pressed on to motor shaft far enough. It was about 0.75-1mm too shallow which caused the end of the worm gear to interfere with the housing and not spin freely. Check the collars on the new motors and make...
  4. LX470MN

    Engine dying while driving intermittently

    I had been cruising on the highway for ~1 hour, engine suddenly lost all power and started coasting. No throttle response. Interior electronics, gauges, and radio were not interrupted. The engine continued to turn until I bumped the shifter into neutral. After stopping, the engine would crank...
  5. LX470MN

    Rear axle bearings pics

    This thread was really helpful for rebuilding my axles, thanks everyone. I ruined the first inner axle seal that I tried to install (using a claw washer from the front hubs). I ended up 3D printing a seal driver that's exactly the right diameter and depth. I uploaded the model here. This was...
  6. LX470MN

    Noise upon deceleration... differential problem?

    I ruined my front diff earlier this year, and your symptoms sound identical to mine. Mine started whirring 1000+ miles from home. The next day I topped off the front diff and it took about 1 quart of oil, so it was very low. Drove it home RWD with the front driveshaft removed. The bearings and...
  7. LX470MN

    100-series SPOTTED: Whose cool 100 did you see?

    Didn't get a chance to say hello, but spotted this 100 in Moab @TRLBOSS
  8. LX470MN

    3D Printed Front Diff Overhaul Plugs

    Front Axle Delete Plugs Printables Link. Useful for temporary RWD operation where the front axles / diff are removed. This plug seals off the backside of the hub where the axle would usually go, protecting the bearings and splines. To install, I put 1 wrap of Gorilla tape around the narrower...
  9. LX470MN

    3D Printed Front Diff Overhaul Plugs

    Printables Link Plugs for axle and pinion holes in differential housing. Useful for power washing, scrubbing, cleaning, and painting the housing without letting any contaminants get inside. Also contains the residual gear oil so it doesn't leak everywhere. Note: The driver's side axle plug...
  10. LX470MN

    Is my Ring/Pinion OK to use, or burnt?

    Thanks guys. New set ordered. Would you say this was caused by running low on oil? Or could it have been set up poorly to begin with?
  11. LX470MN

    Is my Ring/Pinion OK to use, or burnt?

    Situation: Went on a 2000+ mile trip, did some light wheeling in Moab. 2 days and 500 miles later front diff started whining. Mainly 50-55mph and 70-75mph. Immediately topped off all 3 differentials. Rear and center were fine. Front took about 1QT.. So it was very low. After filling, no change...
  12. LX470MN

    LX470 or regular cab short bed tundra?

    You got an especially good deal because you directly lied to me about the rust holes in the tailgate and the power steering system leaking. I had no problem with the other numerous little things like the winch not working, the parking brake being completely seized from rust, shot hood struts...
Back
Top Bottom