Recent content by lostonaroad

belated

TY! At some point, yes. Still torn on what I’ll go with.

Red Cone Extras

Great to meet you, @OGBeno!

Red Cone and Webster.

Lower Crystal Lake/Boreas Pass - Breckenridge, CO The easy stuff before the fun begins while I wait on the melt.

In!

For anyone who keeps these like me.

This thread brings out my hoarding tendencies, I just found 6 of the PTR43-00081 and bought them all...

Great Thread, Thank you!

Serpentine/Tensioner/Idler Pulley - Water Pump looks good too! Took about 2 hours and went from the bottom. Tensioner release bolt is 14mm and is a left thread to allow for you to leverage on it, needed to use a pipe extension. Torques below for reassembly: Tensioner - 6mm Allen is 17 ft/lbs...

idler pulley is 32 ft/lbs

The one I took off required a pipe on my racket so I would imagine about a million there too.

Thank you, @turbo8. Will check out the FSM for the future!

Hi All, Hoping someone on Mud has the Idler Pulley ft/lbs spec for the URJ200? Finishing up Tensioner/Serpentine/Idler Pulley/Checking in on the water pump. Thanks!