Recent content by JSX

I always pack a little grease in the back of any seal with a spring in it to keep it from getting knocked out when driving the seal in.

The Depo headlights come with an adapter on the H1 socket to make it 2 pin (power and ground), which works with the H4 connector.

@kelly saad mentioned working on a sunroof delete panel recently

I use one of these instead of a funnel. Trans fluid pump

On American Racing Headers site Headers

Yes, that works.

Check the steering arm and upper trunion cap bolts on that knuckle, sounds like they're loose.

There's a few ways this has been done for Smartcap canopies, here's one Electric Furnlock

Sorry, my question was a little vague. I was looking for a wiring diagram for the slee harness itself, I do have the instructions. Or better yet, since I have Depo headlights, a wiring diagram to make the low beam bulb switch to high beam when the high beams are on and have the headlights...

Is there a wiring diagram anywhere to do this?

1991-1997 Toyota Land Cruiser FJ80 / 1995-1997 Lexus LX450 Clear Corner Lights - https://www.uniquestyleracingstore.com/products/1991-1997-toyota-land-cruiser-fj80-depo-clear-corner-lights-cltyfj8091cclr Corner lights

Nice, I removed my flares and don't want the tires sticking out. Probably going with pizza cutters, how wide are your tires?

Those look good, did you have to use spacers?

Pull the trim, it's easy. No possibility of rattling if there's nothing left in there!