Recent content by FlyingDevil42

Finally passed the break in period today while I was out getting hurricane supplies here in NW FL. Window shutters up. Hopefully Michael doesn’t move any more west!

Still around? Myself and uscmas412 could meet up in our 80s!

Back up and runnning! The final fix for the no start was removing the distributor, matching the hash on the wheel for the timing chain with zero then re installing the distributor with the hash marks on the spline also lined up...aka how the fsm lays it out. :bang: Cranks up no problem now...

Found the end. Just inside of the the bumper. Thanks for the input.

Still chasing the end. It’s routed down then thru the bumper into the frame. Haven’t found where it comes out and I don’t have any extra gauges inside.

Replacing my phh as well as some other cut lines and came across this. It’s a P.O. mod. Does anyone know what this is? My plan is to just replace with an oem hose and remove this. Thanks!

Anyone have a quick pic of their setup? I bought my 80 with an arb bumper already installed but not the wiring so I'll have to buy/rig something up. Just looking for something to replicate. Thanks!

FWIW I just replaced the booster. Brakes have been working great.

Forgot to post but completed the brake booster swap on Wednesday with the A1 Cardone booster from amazon. No issues so far and loving not having to stand on the brakes. I'll follow up if I see any issues but so far satisfied with the part and glad I didn't have to fork over $500.

Finally purchased my 97 cruiser after watching two of my buddies buy and start work on theirs. It already had a lot of the upgrades that I wanted to do (arb front bumper, 3" old man emu lift, arb rear air locker, arb air compressor, fox 2.0 shocks, trident 8" LED lights, 4.88 gears front and...

Same exact problem. Checked with a multimeter and it had a lower output for the flash on the right than the left side which works fine. I was going to replace the whole harness but you're saying that yours was just a loose wire? Could you tell where the loose wire was?

I'd check the 10a stop fuse ;)