Recent content by easyjteasy

03 LX I had a short in the wiring harness of my after market radio that caused me to lose all instrument panel functions. No gauge movement at all and have a parasitic draw on the battery. I have to jump it after a day or two without driving. I replaced the faulty wiring harness, but it did not...

I checked a few. I'll do a more thorough check when I get this harness fixed.

So my A/C controls recently quit working and I'm stuck on hot/defrost. Sucks having to roll down my windows to suck the hot air out occasionally. I think my harness was bad, as I caught a frayed wire/pin during the install. (see pic) I remember when I taped it up during the install, the A/C...

I've done this like 5 times with no luck. The temp/fan buttons "react" but don't do anything. Any recommendations? ETA: Got it working. Turns out the installer did not plug one of the plugs into the back of the new screen. Also, one of my wires/pins that connected to the CANbus "decoder"...

Have one on my 03 lx. Had it professionally installed

Need to replace mine. Thanks.

Try high country 4x4? Good people over there.

First pic is right after I bought her.

I just got mine installed by a 4x4 shop and think it looks great. I’m seeing no symmetry issues that some of the previous threads mentioned. Hope you get it worked out OP.

Thanks for the input. You can see in the above diagram (at 85317) that there is one socket/connector that feeds three two pumps. I'll get out there with a multimeter to see if I'm getting 12v at the connector from the wiring. Wonder what the third connection to the front of the fluid basin is...

Thanks for this. Was able to find the pumps. Everything appears to be hooked up but nothing is working, which seems to tell me that there is a wiring issue. Not sure what to do.

I'm also having a fluid pump issue. I had some front left bumper damage, and it's possible that the shop didnt hook these back up (neither front nor rear are working). Is the best way to check these from below? I took a brief look the other day but there was snow on the ground and didnt have a...

I did this mod last week. Actually pretty straightforward. I used these sockets: Sockets For wiring: Black and white ground wire from the original corner/marker light to the black ground wire on the socket. Green positive wire from the original corner/marker light to the blue wire on the...

I did this mod last week. Actually pretty straightforward. ARB on an LX470 (Turn Signal Clarification) - https://forum.ih8mud.com/threads/arb-on-an-lx470-turn-signal-clarification.927721/post-10367312 I used these sockets: Sockets For wiring: Black and white ground wire from the original...