Its definitely possible and shouldnt be too difficult. Its been awhile since I had the seat fully apart but I believe popping off the back cover should expose everything you need to reach.
Just installed this armrest using your instructions. Solid 10 out of 10 and a great mod. I have been trying to find a proper armrest for the 80 for a long time. I used to rely on cheap Amazon options that just slotted in place and were always loose and unstable.
It definitely took me longer...
Sorry I should have been more clear. I have upgraded all the cables from jeepcables.com. I got the largest size as well to coincide with the Jag alts increased output. It idles so much smoother now but im still not seeing enough output at idle from the alternator.
I recently installed the Jag alternator upgrade and replaced all the appropriate cables as well. However, I’m still running into issues at idle when using my accessories. I had a good-condition 80A Denso alternator before this, and it had the same issue. I assumed the Jag swap would fix the idle...
If you're going to end up doing a HG you might as well pull the engine/trans and reseal everything. At first I started my HG job with the engine in the vehicle. Such a pain and I got through a lot of the work when I decided to just pull it out anyways. Its definitely worth it to pull and go...
Youll need spacers so the winch isnt contacting the bumper. I just installed the winch into the bumper and put the bumper on the truck. Mark the outline and take the bumper off. Its pretty flimsy but the grill had cracks in it beforehand. Its a spare grill and id rather have the warn 8274...
Appreciate the design and upload! Im just wondering if you've tried this over rough terrain? I printed one out as Ive also been looking for somewhere to mount my UV5R. It seems to stick out quite far from the dash and wondering if the weight of the baofeng will be too much for it. I am thinking...
Ive also been using this style of armrest and its been working great! Cheap on amazon as well. I havent bolted it to my center console yet. Its just wedged between the console and ebrake. Theres a bit of lateral movement as its not bolted down but it hasnt been an issue for me. Ebrake is still...
Thank you! It is running 315/70/17s and its on a 2.5" medium OME lift with 1" spacers. The tent is just a unnamed China clone we got it basically for free to do some testing. We used to do the sleeping inside the cabin thing, but I didn't enjoy taking out all our gear and finding somewhere to...
I was told these are Pro Comps with a -6 offset. I dont have rear panhard correction so the only rubbing is at full flex driver rear. With extended bumpstops I dont get any rubbing. Fitment is really good otherwise. Right up to the edge of the fender.
IMO It wasnt difficult putting in the new engine mounts with the studs left untouched. Just like you said, I just needed to lift the engine a little bit more. The only benefit to me with trimming the stud would be to minimize the amount of time trying to fiddle with putting the mount in place. I...