Recent content by carwashguy

  1. carwashguy

    Wandering all over the road

    Driveline
  2. carwashguy

    Wandering all over the road

    Rear panhard
  3. carwashguy

    Wandering all over the road

    Here’s a few rainy day pictures. Everything at the house was out of feed so I drove the cruiser to the feed store. The pic is it setting with 500 pound of feed in the back. As far as the wife goes she’s a trooper. I’ve drug her several hours away to pick up vehicles. She loves road trips...
  4. carwashguy

    Wandering all over the road

    I drove the rig for probably 40 miles prior to purchase. It wasn’t a spur of the moment purchase. It was almost a month of my wife and I driving back and forth 4 times I believe before I pulled the trigger and brought it home. I am fairly mechanically inclined and will tackle most anything I...
  5. carwashguy

    Build 1995 full resto build

    Beautiful
  6. carwashguy

    Wandering all over the road

    The rig was BOUGHT the way it is right now. I’m not bogging it or rock climbing with it. It was too clean for me to pass up. I understand that the lift is not ideal. It’s just where it’s at right now. I’m weighing my options. If a new set of arms will make it driveable that’s an option. If I...
  7. carwashguy

    Wandering all over the road

    This is why I came onto this forum. Thank you for taking the time to explain it to where I can understand it. I’m sure that a lot of my play is coming from the tie rods hitting the arms. I’m looking at deltas arms now.
  8. carwashguy

    First post to the forum.

    The running boards are powered Power up and down when you open the corresponding door. They are lighted when in operation. Once closed they remain lit up for about 20 seconds. Not the smoothest operating and I’m sure the first time you drag them on anything there destroyed. If I was going to...
  9. carwashguy

    First post to the forum.

    I go into lots of commercial truck shops. I’m building an automatic to wash tractor and trailers. Just finished my prototype in Grand Rapids. Think I’ve got a winner.
  10. carwashguy

    Wandering all over the road

    Been reading on this forum for a few months. Forums like this are life savers for do it yourself guys. Appreciate the suggestions. Thank you for the quick responses.
  11. carwashguy

    Wandering all over the road

    The shop that does all of my sketchy alignment jobs more than likely doesn’t have a printer honestly. I’ll measure it out in a day or two. I dont have any history on this vehicle so I’m shooting blind. I believe the frame and all suspension components are fairly new. It’s almost like the body...
  12. carwashguy

    Wandering all over the road

    I did not get a printout on the alignment. As soon as I can get it in my garage I’ll pull tires and measure it. The all over the road feels like it starts in the front like it’s wandering at the slightest correction it comes back and wants to go the other way with just the smallest of...
  13. carwashguy

    Wandering all over the road

    Bushings in the rear look good as well.
  14. carwashguy

    First post to the forum.

    The running boards was done from a company out of miami
  15. carwashguy

    Wandering all over the road

    It’s setting at 27 inches from center of hub to fender flare on all 4 corners give or take a 1/4 or so. Tires are 37x13.5 r22.Bushings look good without taking everything apart. Only suspicious ones are on the front seat bar.
Back
Top Bottom