Recent content by beveldrive

I finally got motivated to find a solution yesterday. As many have noted, the built-in wireless charger in 16+ LC 200s is lacking. I pulled the dash apart and separated the phone charger tray from the wireless charger module. I am planning on using a MagSafe charger powered from the cigarette...

150$ - local pickup Los Alamos NM (shipping a used fuel tank is doable but not trivial) Used Titan Trail Trekker II No damage Previously mounted on swing away spare tire carrier for a 200 Land Cruiser. Comes with spare tire mount for 5 x 150 lug pattern (others available from Titan) More...

I didn't work out a decent solution after starting this thread and ultimately decided to take advantage of one of the 25% off and free shipping deals to purchase new headlamps (it was still $$$$). I daily drive my LC and couldn't be down for any length of time so was reluctant to remove the hazy...

On a related note, has anyone found the transfer case actuator motor/electronics cover gaskets available separately from the whole transfer case actuator? I had to go in a couple months ago and clean up the contacts to address the morning startup CDL flashing. When reassembling I pinched one of...

Installed the drkdss kit today. Very straightforward and went smoothly. A couple pics... Before: After: The kit and installation video are awesome! Well thought out. I took the 200 out on some roads that upset the suspension on curves and the improvement is quite noticeable. To me it feels...

Guys, thanks for all the feedback. We will air down on our next outing and keep speeds in check. It's not like we were out rallying, but there is always room to go a bit slower. WRT the question about the Cooper AT3 4S tires we were running earlier: I loved those tires for their road manners...

We've been tackling the NMBDR in sections as weekends allow. This past weekend was to be final completion by finishing the Jornada del Muerto and Gila areas. Unfortunately, we continue to have tire issues and I'd be interested in thoughts regarding what we are doing wrong. We started the NMBDR...

Very interested in your plan.

18" Method 705 +25mm offset. 2" OME lift.

Installed Owl Expedition ASAP flaps. Great kit. Straight forward installation. No hardware issues.

RV level:

Can you post a pic?

In the 2016+ the low and high beams are LED with no access. However, the turn signal light is still an incandescent bulb. The access for this bulb goes directly into the body of the headlight.

The outside of my headlights are in pretty good shape. We do have alot of rocks on NM roads, as evidenced by the chip in my front camera, but my headlights are intact. The vaporization comment from bloc is interesting. The fogging looks like condensation, but not typical water condensation (and...