Recent content by Alex7

A little late to the post, but did you get to keep the phone ? :D

Hey @cruisermatt , if there is interest, do we contact you ? Site says out of stock. Thanks. (sorry to OP for the hijack)

Rust Farmers have some in stock. Restored set and unrestored.

these look great. So these will be the manifold and the entire rear section ?

I feel like these are some of the best adventures. Given, I've never done it to grab a 60 series, it was usually a return trip home in a more modern car that can go a lot faster - so dependent on how far you're going, I think it would actually be kind of exciting.

Damn it. missed - Im local lol

Wow, makes me feel like I could try my whole roof. Mess it up.. throw the rack on it. lol

Ah, thank you, I remembered your post but didnt realize the additional feature there at the time. Very nice !

@dbbowen does your 4x4 labs rear bumper have lips/rounded edges on the side protective panels ? I have seen some that are just thin edges whereas yours look like an extra/nicer rounded edge ? Thanks.

**deleted** I searched. lol

Has anyone else's steering relay rod clamps come loose/undone so much to the point where they almost rotate in place ? Today I was under the truck tracking a coolant leak and bumped one of these clamps and one spun around half way. Because the clamp was loose, I think it allowed the rod itself...

Thanks Matt!

Once you remove/replace this can you update if it was pressurized or not ? Im assuming it is fuel ?? Or can we just remove/replace

I dont know man .... would make potential future acquisitions easier !

There might be, hasn't been in the last few years ...