Recent content by 808keith

I ran a tundra muffler on mine for a while. Made it really quiet. But like others say, it’s very very tight fit. In the end I changed it out to a borla muffler with some vibrant resonators. Love the way it sounds now and no drone.

Can I get the file please? Thanks. hiratakk@gmail.com

I did mine right at about 6K. If I didn’t use the Holley Xmax, I’d be under 5K. Lower if I didn’t refresh gaskets and such too.

17x9 SSW’s

I’ll check it out tomorrow morning and report back. I have a lot of room from the heads to the firewall though from memory.

Stitch welded some angle iron to help spread load along and edge of the chassis and box tube ties it into the pan hard bracket.

Thanks for the idea 👍🏽

Yes. I have plenty of scrap steel. I’ll drink some beers while I ponder how I want to do this 😜

I found out why my 80 was suddenly started to wander again. No parts old or worn on the front. With my son moving the steering wheel back and forth, I could see the crack at the base of the pan hard bar mount. Time to bust out the welder and see how I can best reinforce this.

I’m also running the Aussie door cards. my Taiwanese knock-off inner wipers just got delivered. Time to figure out they are installed. I bought the door cards from a friend that decided to go a different route.

mine does the same but I think it was like that before I LS swapped mine. I have a new float assembly that I need to install to see if that fixes the issue, technically, it should. Just had other projects going on lol...

was there ever a group buy on these panels? I checked his site and only see the ball reinforcement pieces.

Since it was revived from 2006 I’ll play too 🤣.. i made mine on the passenger side to offset gas tank.