Recent content by 12bit

Here is what 17" FJ Cruiser steel wheels (42611-35430) look like on a stock 1997 FZJ-80 CE. No lift. No wheel spacers. Tires are Michelin Defender LTX M/S 265 70r17. The wheels are a bit inboard, but no issues. Not a huge fan of the look and I likely won't keep this setup on this truck. Just...

An 80 with it's own anthem. Nice :cool:

time travel? real. an 80 series going 88 mph? fiction.

Time to install a window rocket rocket.

I believe you are looking for 90105-06097

Thanks everyone!

Anyone have a pic of the wiring harness routing near the o2 sensors on a 97? Can't figure out which connector is for the upstream vs downstream sensor.

I suspect if you remove that hitch cover the absolute carnage will be more visible.

I've used 2x OEM part# 89465-69115 installed on the exhaust manifolds on both of my 94s.

it gets even more interesting when the posts the bots are scraping are made by bots themselves.. ♻️

What did you do with the blue connector on the VSV harness? (Since the VSV 90910-12079 is deleted)

T-case is still on the ground. I need to overthink that reinstallation before I proceed with the fun stuff. I suspect it will be a pain.

Went ahead and installed it myself last night. Pulled the transfer case to make it easier to manage alone. There is no lift in this truck, but I still aired down my front tires to give me more clearance. Went in without too much drama. Putting in the motor mounts last was definitely helpful...

Yep. Harness is brand new. New short block and head, also. The cherry picker is a 2 ton from Northern Tool. I pulled the motor and transmission without issues, but it's probably pretty close to it's limit.

I did replace the rear heater lines, but haven't considered coating the transmission tunnel. I think I may do that. What do you recommend?