I'm sure this is a super basic question, but I'm a 1 bannana mechanic, and I don't even know what to google to get the right parts.
I swapped the trans out of an 85, into my 80, (because the original trans was toast, and i had the 85 already
I put 85 drive shafts in because the lengths were right, but only 2 holes line up where the drive shaft.
Can anyone tell me what parts I need to get to change out the flange on the axle side to match the 80 pinions flanges?
I tried just drilling the rear pinion flange and it turned into a mess, breaking like 3 11mm drillbits, before my brother told me just to swap the flanges.
If there is a walk-through on swapping them, that would be awesome too.
Thanks,
Eric-
I swapped the trans out of an 85, into my 80, (because the original trans was toast, and i had the 85 already
I put 85 drive shafts in because the lengths were right, but only 2 holes line up where the drive shaft.
Can anyone tell me what parts I need to get to change out the flange on the axle side to match the 80 pinions flanges?
I tried just drilling the rear pinion flange and it turned into a mess, breaking like 3 11mm drillbits, before my brother told me just to swap the flanges.
If there is a walk-through on swapping them, that would be awesome too.
Thanks,
Eric-