World's Fastest 80

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 27, 2003
Threads
182
Messages
4,622
Location
Socal
I'm sure this is a repost but I thought it would be nice to revisit w/ all the forced induction talk
http://autospeed.drive.com.au/cms/article.html?&A=0950
0950_6mg.jpg

0950_4mg.jpg


thought this was interesting as I am mounting my resiv. the same way
0950_7mg.jpg
 
How much booste makes a ifzfe more powerfull than a new tundra 5.7?
More torque?

Enough to get more than 381HP and 401ft-lb :D
 
How much booste makes a ifzfe more powerfull than a new tundra 5.7?
More torque?

It should take about 6-7 psi to get a stock 1FZ-FE to over 400lbs of torque and probably near 12 psi to get it to 380HP. Obviously you cannot run 12psi on a stock motor.

edit: these are pretty rough calculations
 
Last edited:
The guy who owns that 80 also owns an Mercedes SLK with an SLR engine fitted into it!

If you check out the speedometer, you can see the letters BSP (http://www.bspturbo.com/index.htm) which stand for Ben Sulayem Performance!
 
Well.. you can just turn it lil close 15 psi.. it should be awwright... :D
C-yaa Tundra :flipoff2:

nice! but, no way you are doing that on a stock block/head with any gas you can easily buy! ;p

I'm dreaming of giving my 1FZ the treatment I gave my 2JZ. :grinpimp:
 
It should take about 6-7 psi to get a stock 1FZ-FE to over 400lbs of torque and probably near 12 psi to get it to 380HP. Obviously you cannot run 12psi on a stock motor.

edit: these are pretty rough calculations

Not arguing against you but you can run 12psi on a stock motor, its been done many a time for many a miles. I would think that 10 psi would produce 380HP, I'm preparing to test that theory pretty soon here, but, alas, if it takes 12, well, so be it!!! :D :flipoff2: :D
 
Not arguing against you but you can run 12psi on a stock motor, its been done many a time for many a miles. I would think that 10 psi would produce 380HP, I'm preparing to test that theory pretty soon here, but, alas, if it takes 12, well, so be it!!! :D :flipoff2: :D

Now I'm interested. What octane gas? What fuel mods? Timing?

We might just turn this thread tech. :D
 
Damn! Check out the brakes! I too am interested in a set-up like that.
 
This guy is running a boosted (22psi) 1FZ-FE with a modified fuel delivery system. The engine itself is basically stock.

http://www.performanceforums.com/forums/showthread.php?t=67218679

Yes, the key there is he lowered the compression. What I was getting at is at stock compression, you've had a hard time running that much boost without also having to run some high octane race fuel.

Edit: Actually, 9:1 is not that bad. I had in my mind that our static compression ratio was higher?
 
Last edited:
Back
Top Bottom