Will it do DAMAGE?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 13, 2006
Threads
124
Messages
986
Location
Santa Monica, CA
Website
www.elirubelphotography.com
I am getting close to the end of my frame off build... a few weeks out...any way, The rear diff is put together...just not sealed yet, and I noticed I have the spider gear spacers for the sides, but not the top ones....so the center peice has a good amount of play room...I plan on putting the spacers in, but was hoping that I could take it down to toyota, so when I order the spacers, they order the right size (I believe I was told they come in three thicknesses)...The question is, could I do damage driving it with this amount of slack?....or is it risky in any way?

1.webp

2.webp

3.webp

:beer:

Thanks


Eli
1.webp
2.webp
3.webp
 
You mean that you have the thrust washers for the axle gears, but not the smaller, "cupped" ones for the spider gears?

I've got a bucket of them here too (but shipping from Steve has got to be quicker).

I wouldn't go to the trouble of putting a diff together worng, just to take it apart again. Are you wanting to assemble it, drive it to the dealer, open it up, measure it, button it back up order the parts, drive it home to wait.... Never mind I know that can't be what you mean, but to be honest I am confused as to what you are thinking abut doing..

Anyway, It's hard to say if it would hurt things much if you were very gentle, but the teeth won't line up properly and it won't be good for anything.

I'm not sure that these come in different thicknesses like the thrust washers for the axle gears.


Mark...
 
put in a aussie, throw them spiders in the can.. i called the toyota dealer and the parts person advised those come in multilple thicknesses ... they same for the c clips .. depending on what year ya got ..


good luck ,, :beer:
 
Back
Top Bottom