SOLD Wild WY! Door & tub cuts from a 1970 FJ40. All proceeds benefit local youth injured in hit & run accident. "Toasty" wants to give back all she can!

[Denscustom1]

Location

United States

I recently took door cuts for Wadesters from "Toasty" a 4/1970 FJ40 that was lost to a garage fire. I am offering up any other door or body cuts for the cost of shipping. Any donations in addition to that will go to a local youth that was injured in a hit & run accident while riding his bicycle. I'm not looking to attempt to unbolt any pieces since most of the hardware is seized, but happy to take requests for cuts. Please reply in thread. Thanks, Dennis

 

[kevos37]

I'll start... Gas tank filler surround sheetmetal. $50 plus ship?

 

[Denscustom1]

Yes sir! I can do that. Thanks, Dennis

 

[hyhpe]

I’ll send 50.00 for a donation. Your usual PayPal?

 

[Denscustom1]

Yes sir! Thank you for that!

 

[Denscustom1]

I'll start... Gas tank filler surround sheetmetal. $50 plus ship?

Cut to inside of tape look good to you?

 

[kevos37]

Cut to inside of tape look good to you?

View attachment 3128771

Yes sir

 

[hyhpe]

Done. Thank you.

 

[65swb45]

How’s the transmission hump? Doesn’t matter if all the bolts snap off.

 

[Denscustom1]

Pretty rough along the flange after sitting outside for years with the remnants of the fire holding water…..pine cone is in good shape though!!!!

 

[65swb45]

Pic of pine cone…or it didn’t happen!

I’ve actually got a hump with a good flange that someone had some anger management issues with topside. I’m not sure, but I think I posted a pic of it in @Skreddy thread. I might still want the top section to try a graft.

 

[Denscustom1]

Sounds good! I think I may have seen that mangled mess.

 

[waltermayorga]

Interested in 2 door hinges, the wing vent shaft with hardware, and hard top channels

 

[Denscustom1]

Which door hinges? Which vent shaft? You want complete hard top channels? Let me know measurements of cut for channels. Driver's side does have a bend to it. Thanks, Dennis

 

[waltermayorga]

Which door hinges? Which vent shaft? You want complete hard top channels? Let me know measurements of cut for channels. Driver's side does have a bend to it. Thanks, Dennis

Actually I would like to take the 4 door hinges if possible. Problem is I just realized about the unbolt restriction of the thread

 

[Denscustom1]

I can work with you on those. Make a viable donation for the kid in the hospital and they are yours!

 

[KT40]

Heater vent and surround for $50?

 

[Trippster]

I sent 50.00 for the kids.

Thank you Dennis

 

[Denscustom1]

Heater vent and surround for $50?
View attachment 3129441

You bet! Do you need a cut around the vent? Thanks, Dennis

 

[Denscustom1]

I sent 50.00 for the kids.

Thank you Dennis

You guys are the best!