What do I have? 40 newb (2 Viewers)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Drove home the donor this evening.

IMG_2079.jpeg


IMG_2080.jpeg


IMG_2081.jpeg
 
Remove the intake to pull engine with less chance of breaking anything. Fresh knock sensors and harness, cam sensor and intake gaskets.
LS maintenance
Those little bits add up to replace new.
 
I think I have everything I need minus fuel lines and a couple other little things.

Although my manifolds have not shipped and I was told today they might not until next week 🙄

But I can make progress.

Valve cover gaskets, oil pan gasket, engine clean up tomorrow.

And call Mark about a top plate.

IMG_2117.jpeg
 
You work much faster than me. I’d still be wondering how to pull the F. I think most of my time is spent just staring at the project before I actually pick up a wrench.
 
You work much faster than me. I’d still be wondering how to pull the F. I think most of my time is spent just staring at the project before I actually pick up a wrench.

90% of what I have done to this point has been during my lunch hour. I live 2 miles from work so I haul ass home, wrench, haul ass to work.

I’ve traded eating lunch for getting the 40 back on the road. 😂
 
I have a few sets of manifolds if you need them faster
 
I have a few sets of manifolds if you need them faster

Which ones do you have Matt?

I didn’t follow suit and ordered the Hooker center dump manifolds after looking them over.

The summit ones you listed earlier in the thread appear to exit at the rear which I think will conflict with my passenger side slave cyl.
 
G9080. I’m looking forwards to seeing how those new center dump ones fit
 
180 out of the passenger side down in front of the oil pan sump, and around and merge on the driver’s side
 

Users who are viewing this thread

Back
Top Bottom