Spark plug wires

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 26, 2014
Threads
80
Messages
1,411
Location
Tucson, AZ
I’m looking for pictures of stock routing of the wires from the distributor to the spark plugs. Mine was not set up correctly but ran ok, when I put them to the right plugs on the distributor, nothing. I failed to take a picture of the routing before I changed it and am looking to see what you all have to see how deep I need to delve as to why..
 
So, it ran, then you switched the wires and now it doesn’t. What do you mean by “Mine was not set up correctly”? Does your distributor cap have numbers on it? The distributor may have been rotated around for some reason like clearance issues and the wires may have been rotationally correct but the numbers on the cap just didn’t match up. Some pictures would help us help you.
You may have to use the method in the pic below to get it squared away.

Dizzy Set 01.webp
 
were the wires 180 degrees off from where they should be?
chances are someone installed the distributor on the exhaust stroke not the compression stroke
it's ok like that you just need to be aware of it. or just fix it
 
Top Dead Center on number 1 cylinder is when the valves have space between the rocker arm, and the piston is up top in the spark plug hole. #6 TDC also occurs with the pointer at the same part of the window - there are two full turns of crank rotation for every full turn of distributor.

The placement of the wires on the cap matters only to the rotor, their sequence is must be correct.
 
Last edited:
I’m looking for pictures of stock routing of the wires. I failed to take a picture of the routing before I changed it

You first, LOL. Take some pics of your wire routing as it is now and post up. Good pics motivate the gurus who also sometimes spot things that a lot of us don’t.
 
Ok, so I used a picture I found of one and a half of the wires. I found from that and the firing sequence, that it I needed to shift them to the right by one. Now it runs and idles. After looking at the timing I’m off by almost half an inch to a full inch from the indicator. Thanks for the tips all.
 
Ok, so I used a picture I found of one and a half of the wires. I found from that and the firing sequence, that it I needed to shift them to the right by one. Now it runs and idles. After looking at the timing I’m off by almost half an inch to a full inch from the indicator. Thanks for the tips all.


dont forget to remember , to secure both distributer clamp bolts , the 10mm squeeze on around the shaft , then the 12mm hex one on the clamp itself goes down in block vertical ...


Seth , do you have installed the TOYOTA Updated single bolts style dizzy clamp

or

the original 2 bolts one ?

the updated one looks like this :

if you don't , you should seriously consider installing the updated design one..

for good measure and to prevent any possible future issues ....

holds your final set timing better secure then the 2 bolt older version ...


Cowboy , would be happier too ........ :D


1579072784551.webp
 
Back
Top Bottom