Rust Repair: Fuel Door

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 11, 2004
Threads
73
Messages
1,190
Location
Tampa
Luckily my '76 has relatively little rust, however there are a few spots that need attention and I intend to repair them the right way - with new metal.
That said, I had no welding experience, no welder, and knew nothing about MIG (GMAW) welding - nada. Picked up a HH140 and decided to try my hand at it. For some reason my fuel door has rust holes in the bottom of it. No rust around the fuel filler recession - just the door. So I figured this would be a good opportunity for me to learn on - something relatively small - easy right? Not really, at least not for me just starting out. Nonetheless, I did learn a bunch doing it and here are some pics to document the process:

Getting started:
 
Last edited:
Nice work.... I need to do the same type of fix on my rear doors...small pin holes.
 
Take your time with the larger pieces of sheet metal. Make stiches all the way around, sheet metal is prone to warping if you try to run a long line. -- You probably already know this, but I didn't and it sucks.

But good luck with your ride and any future work. :beer:
 
You're right on the warpage - I picked up some scrap 22 ga and after only about a 1" bead on relatively low heat - it was instantly warped. I guess stitch welding and hopping around from spot to spot is the best way to keep a panel from getting too hot. I believe Stemple (sp.?) crayons are available to indicate when the metal reaches a certain temp - when this happens the mark you made on the panel melts away - could be a useful aid for a beginner like me. Infrared thermometer would be nice too.
 
You can avoid using a backing plate, on small holes, by buying a thick piece of brass 2x3 or similiar size. Most welding supply stores have them. Some have them on a handle. Place the brass on the back side of the hole. When you begin to weld the brass bleeds heat from the sheet metal keeping it from warping. It will still warp if you keep the heat on it too long. Begin working your way around the edge of the hole building material up. Be careful not to burn through or blow the edge out. Keep working your way around slowly letting the heat disapate. Nice job on your first pass. We all learn the hard way-trial and error:)
 
seems like alot of work and it looks good, did you do for the practice mostly. wouldnt it be easiest to buy a new ( used ) one?



nice work
 
wouldnt it be easiest to buy a new ( used ) one?

Absolutely. You can probably pick one up for under $20 used. For me the main point of the exercise was to learn how the weld puddle flows, how to control heat, and how to shape with the grinder. The other benefit is if I screwed up - I'm only out $20 - versus learning on a brand new quarter panel and blowing close to $300. So in the end, it was worth the time and effort - plus I was able to salvage an original part.
 
It looks good. There's nothing as satisfying as looking at a part that has been saved from the scrap heap. Keep up the good work.
 
Back
Top Bottom