Rides Like A Caddy Now

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 2, 2004
Threads
81
Messages
602
Location
Western Slope, CO
Hey thanks CruisinGA for the tip. Loosened my shackle bolts some and pulled the AAL in the rear. Also fixed my inverted shackle angles and man I never knew that a 40 could ride this good, no kiddin it's like actually pleasant to drive now. I used to know every bump in the road from home to work, now I aim for 'em :bounce: Gonna be interesting to see that axle actually flex now! Might have to trim the rear a little with those 34s now :eek: Hey it sit level now minus the 250lbs of sand in the back. :cheers:
Shackle fix02.webp
Shackle fix03.webp
Shackle fix04.webp
 
So what you're saying is swap em where the shackle bolt goes through the spring eye?
 
how do you loosen the bolt without the nut falling off? one of the bolts on a rear shackle became loose, and i almost had the shackle fall off.
 
Sorry, had to go to bed. What CruisinGA said. I just got a lift kit with these shackles and the way he pictured it was the way the instructions were for the kit. The kit said the middle bolt should be towards the top to hit the frame, like he said. People who say it with pictures make so much more sense.

Les
 
rusmannx said:
how do you loosen the bolt without the nut falling off? one of the bolts on a rear shackle became loose, and i almost had the shackle fall off.

Pull off the nut and crush it in a vice so as to be out of round (barely), then re-thread.
 
I use nylocs or I use 2 nuts. Whatever you use, you should check them periodically, the motion of the shackle can loosen about anything.
 
Thanks for the help guys. It's funny thinking back to what the PO told me "yeah ever since I put that little lift on the damn things been too damn rough for me to drive" and just think I been bouncing around for the last six months until someone this board says "hey that looks inverted man" so yeah, damn good bunch of people here....great site!
 
wtmtnterror said:
Hey thanks CruisinGA for the tip. Loosened my shackle bolts some and pulled the AAL in the rear. QUOTE]

What is the "AAL in the rear"

AAL?

Thanks

Rezarf <><
 
add a leaf I suspect

REZARF said:
wtmtnterror said:
Hey thanks CruisinGA for the tip. Loosened my shackle bolts some and pulled the AAL in the rear. QUOTE]

What is the "AAL in the rear"

AAL?

Thanks

Rezarf <><
 
REZARF said:
Wow, I just became irregular!

thanks for sharing...lol

if you have concerns about the nuts loosening, switch to nylocks. I've run those for many many years on my shackles with no problems. Should be able to find SAE and metric sizes out there.
 
I think someone was worried about mine coming off cause they must have been tightened down with a 4 foot cheater bar! So they should just be snug right? think I will get some nylocks for it though. So the general concensus is I still need to rotate my shackles right?
 
looks alot better, she probably dont ride like a tank anymore either. take her wheeling and see how it flexes
 
another way to set up

your suspension is to keep everything loose untill you get it on the ground.
then tighten everything up, but do not over thighten your spring eye bolts,or crush the bushings. .02
 
Back
Top Bottom