replacing clutch, just disk or complete kit?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I am replacing my clutch on a 73 FJ40 and wanted to know, should I just get the disk and alignemnt tool, or should I get a complete kit. Oil leaked out of my rear main and the PO didn't fix it so it got oil on the clutch disk. What are suggestions. I will buy OEM parts.
 
You didn't do the last clutch job, the PO did, right? Kind of risky to assume he resurfaced the flywheel and replaced the pressure plate the last time it was apart and that there are only a few hundred miles on the new setup. It isn't worth it unless you like pulling the drivetrain apart in your spare time.

On the other hand, if you know all the parts were new or reconditioned and they only have a few miles on them, you could get by with just a disk. I wouldn't do it unless you're sure. POs are notorious.;)
 
VTFJ40 said:
What he said.



Including the rear main seal. I got my flywheel resurfaced for $35. New pilot bearing, TO bearing.


GL

Ed
 
Thanks. I am getting SOR's clutch kit and the fly wheel resurfaced along with doing the rear main and the seal on the transmission. Thanks again all.
 
projektdotnet said:


Heck I did it with my CJ but I do not rush it. Plan on doing it for a few hours here and there. I figure a month over January and a few tricks like longer bolts to start lining up the tranny and work my way closer with smaller and smaller bolts until it is lined up to the engine.
 
I'll go ahead and save you the post and headache a month from now-

The two easiest ways to remove the pilot bearing out of the crank (I've tried them all) Is to either use a slide hammer with a fashioned "hook" (I modified an included attachment, could also use carraige bolt)

Or, use a carriage bolt and grind it into a hook that very snugly has to be worked into the pilot bearing, and then a nut, washer, and socket to pull the bearing out.

I've had relatively quick success with both methods.

Good luck!
 
CruisinGA said:
I'll go ahead and save you the post and headache a month from now-

The two easiest ways to remove the pilot bearing out of the crank (I've tried them all) Is to either use a slide hammer with a fashioned "hook" (I modified an included attachment, could also use carraige bolt)

Or, use a carriage bolt and grind it into a hook that very snugly has to be worked into the pilot bearing, and then a nut, washer, and socket to pull the bearing out.

I've had relatively quick success with both methods.

Good luck!


what he said
 
Back
Top Bottom