Powersteering Stuff

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 10, 2006
Threads
99
Messages
501
Location
The Ghetto
So, I was driving in my complex parking lot when it took a godly amount of strength to turn left. I finally parked and saw that one of the left front shocks was hanging there. I was like WTF?! One of the nuts came off and now I have to replace. That's besides the point.

Then, as I inspected both of the shocks and there was a rub mark on the same side of each. I came to find out that it was the power steering rod that was rubbing against both shocks. The PO was a dumbass!!:mad:

Is there any type of reroute I could do? I'm going to have to take pics soon so you guys can get a good idea of what the hell is going on.:cheers:
 
a little more info could we use yes.

pics would help alot
 
Here are some pics of what my powersteering issues are about.


ahhh_scrape.webp

ps.webp
ahhh_scrape.webp
ps.webp
 
You can try getting a breaker bar and get the one large nut holding the pitman arm on are tight as you possible can ..

Then you may want to see how far inward you may be able to reposition you steering gearbox..





And if that doesn't look like it'll do much you may need to start considering altering you shock setup


Like projektdotnet said with some ford shock towers (F-150 I believe)
 
Rubbing drag links are a common problem on both manual and power steering cruisers. The problem stems from two things. One, the original shocks were a smaller diameter, so there was a little more clearance. Second, the angularity between the upper shock mount and the lower shock mount decreases as the vehicle is lifted. The higher the lift, the closer the shock gets to the drag link.

Changing the shock tower is the best route.;)

Best

Mark A.
 
Back
Top Bottom