ome install time?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 7, 2003
Threads
402
Messages
13,957
Location
lebanon,pa
Website
www.facebook.com
what's the average install time on an ome lift?
my fasteners don't look too bad, must have been garage kept. and the amount of work doesn't look like much at all.
looks like if everything goes well maybe just a long afternoon?? this reasonable or way off base?
 
You'll kill an afternoon the first time. Of course it gets shorter after you've done it a few times. If you're also doing the CC bushings you may need some more time depending on the tools you have available.

A nice way to save time and energy -- use a bottle jack between the frame and axle to push the axle down so that the springs pop in easier.
 
all i'm doing now is springs and shocks.
it's a heavy 2.5", so i wanted to drive it before deciding if i "need" correction bushing.
steering stabilizer will come later as well.
this all looks way easier than leaf spring lifts, well simpler anyway.
 
Don't do the standard OME shocks, go with the L's. Unless you're running really small tires, or don't like flex. ;)
 
Tip: You can always step on the hub to force it downward if you don't have a bottle jack--just make sure you loosened your brake lines first! Your right, it is a fairly easy install--especially for non-rusty rigs! ;p

Also, you WILL want caster correction of some sort--most likely Slee's Blue bushings or plates.

Jwp
 
Don't do the standard OME shocks, go with the L's. Unless you're running really small tires, or don't like flex. ;)

x2


Install time took me 5 hours. Take it easy on the rear lower shock bolts unless you want to drill, tap, and repeat. Resist the urge to break out he impact wrench here.

As for the CC you will notice it. I drove mine with out for 2 weeks and the truck felt light, un stable, and twitchy. You really will notice how bad it is once you correct the caster. Because the excitement of having your lift finally installed will have worn off.

Also make sure you have some good jack stands. Not worth loosing a leg, foot, or worse b/c you skimped on parts.

Good luck and read up on slee and other sites for other tips and tricks. It helped me alot. Good luck.
 
To do the lift right, loosen all the control arm bolts. This will allow the axle to drop down. No need to force stuff. Then once you have all the tire back on the hubs and the truck setting on the ground. Tighten the lower control arm bolts. This allows the bushing to be in the neutral position instead of being twisted all the time.
 
Well, everyone here is quicker than me.

It was my first time. I did the caster correction bushings and stabilizer, the press wasn't big enough to press the bushings out, so that took muuuuch longer than it should have if I had a press bigger than 20 tons.

Make sure you have a set of deep 6 point sockets otherwise those rear upper mounting plate bolts will give you trouble as mine did. I had to drill and replace 1. Another unexpected delay.

I also took a wire brush to a anything showing rust when I pulled it apart and hit it with the rust stop paint. another time drain.

The complete install took me 11 hours, but It's done and I haven't had to go back to anything.

Good luck.
 
Back
Top Bottom