novice wiring question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 27, 2005
Threads
60
Messages
338
Location
Billings, MT
I am installing 5 autometer guages into my fj40. Each guage has a power and ground wire for the guages light. Can I combine all the power wires together as well as all the ground wires together and wire them into a single power and ground wire (a 5 into 1 arrangement) to run to my 12v power source and ground location? Also, the fuel and the Tach both get wired to the ignition, can I combine these two wires together coming from these two guages into a single wire that will attach onto the aux. post of my ignition switch?

Thanks
 
1) Yes on the panel lights. The clean way to do this is one one power lead to one light and the next and the next rather that a 6 wire to 1 splice.

2) No. The fuel gauge gets power from the key on side of the ignition switch (same as the panel lights). The tachometer gets its signal from the distributor side of the coil (-).
 
Well here's my question. Crimp connectors or solder and shrink wrap on the wires? I've used about a pounds worth of the crimp type connectors and had very little trouble with them but I just got one of those cordless soldering things and thinking............?
 
Solder and shrink wrap are preferred on connections that don't need to be disassembled for removal. Sapde lug crimp connections are OK for things that may need to be removed. Crimp connections are prone to corrosion and oxidation so sometime down the road there will probably be somone cussing you out as the PO.
 
i pefer the solder and shrink wrap, very clean and sturdy connections
 
Back
Top Bottom