Not Now, wtf.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 23, 2009
Threads
62
Messages
744
Location
Oregon
Truck has been running great. Going for breakfast this morning noticed i was losing accelerator pedal response . Then a minute later i completly lost accelerator pedal and rpm's dropped and motor starts to run very rough and shaking the entire truck. Now it will turn over but dies right away. I have no idea what to do. Stuck on the side of the road. Help.
 
Check the air hose for a large crack. Check all vacuum hoses as well to see if they have not torn off or come loose.
 
Did you happen to notice any white smoke or the sweet smell of coolant? Such a slow loss of skinny pedal usually won't occur with a hole in the intake tube, that's usually more sudden unless the hose was slightly cracked and then opened wide suddenly. You may check your timing also, ensure your distributor didn't loosen and turn.
Top things to check:
Fuel level (not to condescend)
Coolant
Oil
Air intake hose
Mass Airflow sensor is plugged in
Distributor hasn't come lose
Cap and rotor (top contact in cap especially)
 
Did you happen to notice any white smoke or the sweet smell of coolant? Such a slow loss of skinny pedal usually won't occur with a hole in the intake tube, that's usually more sudden unless the hose was slightly cracked and then opened wide suddenly. You may check your timing also, ensure your distributor didn't loosen and turn.
Top things to check:
Fuel level (not to condescend)
Coolant
Oil
Air intake hose
Mass Airflow sensor is plugged in
Distributor hasn't come lose
Cap and rotor (top contact in cap especially)
Make sure to also check out the battery connections and fuseable links
 
^^ I second fusible link if nothing obvious. Possibly fuel pump?
 
Get some starter fluid, remove the air hose, and spray it in the throttle body. If the truck runs for a longer time, then dies, you have a fuel problem. Many electrically based components that can go wrong will set a code, but a bad fuel pump or fuel pump relay will not. The fact that it tries to start, but dies should indicate that the spark is OK.
 
If it will start but die see post #2

If it will not start see post #6 above

99% of the time the problem is electrical or fuel and the post #6 above will help determine that.

Starts and die using starting fluid see post #7

Will not start at all using starting fluid see post #4
 
Back
Top Bottom