no-clutch shifting

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Extra wear on the syncros

I won't disagree with anyone who says it's not all that great for your parts, but I can downshift and upshift and I've been doing it all my life. I've never had to replace a manual transmission that I owned for any reason. I don't remember grinding a gear in my 40 yet.

If you know how to do it, you can get home when your hydraulic clutch goes bad. You have to turn off the engine to stop, and start it back up in 2nd.
 
missipboy said:
does shifting through the gears without using the clutch hurt or put any extra wear on the transmission?


not if done properly, went 175,000 miles in my Dakota before the throw out bearing failed, preasure plate and clutch disk were fine. if I could have only changed the bearing I'd still have the original clutch in it
 
badass said:
You mean you don't press the clutch pedal when you change gears?



yep.








I have done it and can do it, but do not make a practice of it, other than in older, over the road tractors...


:beer:
 
Yeah, I do that sometimes. I freaked out one of my friends when he realized what I was doing:flipoff2:
 
had a vw fox that i could'nt give a s*** about.
i could tap the gas(just enough to keep it from stalling when it goes in) from a dead stop and jam it in 1st gear and never grind it. i rarely ever used the clutch in that, short of pulling out once in awhile.

half the time i find myself not using the clutch to shift in the 40, and not even realizing i'm doing:doh:

it is suprisingly easy to do, once you figure out how to do it. downshifting without the clutch is abit more tricky. there you need to match everything pretty close. going up you just let off the gas and ease it in, it will just "click" right in.
 
i'm sure it keeps the mpg from getting too bad also. i've been doing it alot lately and just wanted to make sure i wasn't setting myself up for disaster. thanks for all the opinions, i will continue to do it when i can. at least until gas prices get back down to $1.50.
 
I have found that it is easier to dry shift with a SM420, but there is a reason for the third foot pedal also known as a CLUTCH, if you did not need it why did they build it into the vehicle? I once drive 36 miles home through three towns with out a clutch (NOT BY CHOICE), luckily I was able to time all lights so that I did not have to turn it off once.
 
wow....


that is deep.
 
upshifting, i float the gears most of the time, down shifting is a bit trickier, so i don't do it all that often, but try to do it every so often to keep in tune with the rpms.
 
Back
Top Bottom