SOLD McLean, VA -- Bushing press tools for an FZJ80 and Harbor Freight 20 ton press (1 Viewer)

[awf]

Vehicle Model

1. 80 Series

I've replaced all the bushings and U-joints on my '94 FZJ80, and won't do it again for a decade or more. So the 4 press tools and press are available for $100 total. The jack does weep a bit of oil but works like new. It's a good deal, and I can give 10 minutes of tips if you like when you pick it up.

 

[2001LC]

Great deal for press alone. But my interest is in the "press tool" (drifts) only. Would you sell them and ship? If so can I give the diameter of each drift?

 

[awf]

It's a package deal, since I want the press out of the garage. The press tools/drifts are the sizes for the FZJ80 bushings. I'm trying to help others on the same journey as me, so all that matters is, "If you're doing you're doing your FZJ80 bushings, these are the tools you need."

 

[SteelHunterFJ80]

Your too far away from me so if you don't mind where did you get the drifts? Thane in advance

 

[awf]

The place up in Oregon that went bankrupt, so I’m not much help. But I will say that I cannot imagine doing the job without drifts. The folks who do it with sockets, etc…. It’s tough enough with the right tools. But, once you get up and get going, it’s definitely worth the effort. Definitely keep the new bushings in the freezer until just before you put them in. It makes an amazing difference.

 

[SteelHunterFJ80]

The place up in Oregon that went bankrupt, so I’m not much help. But I will say that I cannot imagine doing the job without drifts. The folks who do it with sockets, etc…. It’s tough enough with the right tools. But, once you get up and get going, it’s definitely worth the effort. Definitely keep the new bushings in the freezer until just before you put them in. It makes an amazing difference.

Thanks. I'll do the freezer thing, your enthusiasm has convinced me