Main cut-off switch for new winch?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

You can use the Hella cut off switch (as pictured above) to cut off the "control" power to the solenoid box rather than the total power to the winch. If no power is going to the control box, then the winch is nonoperational. I wouldn't use it to supply power to a fully loaded winch that can draw over 400 amps when fully loaded.

Cheers.

edit: I see that it's been mentioned already (control relay power).
 
Thanx for the info :)

HF's site says 100 capacity with a 1000 amp surge, but I was kinda leery about those numbers :doh:

Any pix of your setup?


This is what I have on my early Bronco (rated 100 amps continuous and 800 surge).
disconnectSmall.jpg



This is what I have for the Cruiser.
battdisconSmall.jpg
 

Users who are viewing this thread

Back
Top Bottom