Knuckle rebuild question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 18, 2016
Threads
69
Messages
339
Location
Chapin, South Carolina
Ive been pretty busy the past two weeks, completed a full knuckle rebuild with all the parts coming from Cruiser Outfitters. Great kit by the way. Also, installed a new power steering pump, with new custom high pressure line, my 80 is a HDJ81, so those are pretty non existent as far as I could see. Also installed a new ac dryer and accumulator with all new o rings throughout the ac system, with r12 recharge. My question is what do I look for now on the knuckles? Should there be a light coat of grease? I now see a very fine film of grease on the knuckles but no mess. This is the first 80 that I have been apart of redoing the knuckles so I really don’t know what a correct job looks like after.. thanks for any input.
 
A friendly note to put on your calendar to re-tourque the bottom four nuts on the knuckle in about a month, then after every offroading event or year, whatever comes first.

Sounds like you did it right. I personally don't think you can overfill them, but let's not start that war.
 
A friendly note to put on your calendar to re-tourque the bottom four nuts on the knuckle in about a month, then after every offroading event or year, whatever comes first.

Sounds like you did it right. I personally don't think you can overfill them, but let's not start that war.

Seem to remember that it was 70ft-lb for those nuts, correct?
 
A friendly note to put on your calendar to re-tourque the bottom four nuts on the knuckle in about a month, then after every offroading event or year, whatever comes first.

Sounds like you did it right. I personally don't think you can overfill them, but let's not start that war.

Yeah, that’s where the doubt came in because there are so many opinions as to how much grease to use.
 
Back
Top Bottom