Wanted Insulator block needed please

[Allingerb]

Location

United States

Iso insulator block with vacuum port that goes between intake manifold and carb for my 1965 with 1f motor. Please

 

[Tancruiser]

I think I have one let me dig around and get back to you

 

[Allingerb]

Thank you much

 

[3_puppies]

I was thinking Mark A had an aluminium? replacement made. best to call him
problem with the 50 year old one is the tube gets loose in the block.
@65swb45

 

[Tancruiser]

Is that a single barrel carb on your cruiser? I found one in my junk but it’s for a 2 barrel.

 

[Allingerb]

Is that a single barrel carb on your cruiser? I found one in my junk but it’s for a 2 barrel.

Sorry for delay. Yes I need the single barrel. Thank you though. I guess I'll look into the replacement.

 

[Allingerb]

Found one. I think

 

[Splangy]

For those of you that need one without the PVC port, you can buy a new one for a 200cid Ford 6 cylinder and drill out the mounting holes an additional 1/16”.

 

[65swb45]

For those of you that need one without the PVC port, you can buy a new one for a 200cid Ford 6 cylinder and drill out the mounting holes an additional 1/16”.

I’ve been wondering about the possibility of some domestic app for this. Is thickness appropriate, per @oregon fj discussion ?

 

[Splangy]

I’ve been wondering about the possibility of some domestic app for this. Is thickness appropriate, per @oregon fj discussion ?

The ones I found on eBay were available in a few different thickness IIRC. Something like 1/4”, 3/8”, etc...