IH8MUD HQ

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

That's looking pretty nice!
 
You'll be tossing a rope to people floating down stream for sure if that place starts to take on water!
 
I'd show the amazing photos of the bathroom, but it got dark out :)

Planning lighting tonight, looks like nine total 8' T8 fixtures on 4 switched banks at the ceiling level...should allow lighting specific areas easily, without breaking the bank. Just haven't found any LED's that are affordable...might do that for the "office" area tho.

Also planning locations for ceiling fans...likely two...even better, these come as a 2-pack :)

Westinghouse 7812700 Industrial 56-Inch Three-Blade Ceiling Fan with Ball Hanger Installation System, White - Ceiling Fan With Remote - Amazon.com
 
Why no separate electric service for the shop? You might want to check into it, I know that my service for the shop is at a lower rate than the house service.
 
Separate meter charge, for one...plus it's all one lot/property...no one I spoke with felt it was cost effective
 
Just realized I lost my silver star, I thought we'd get a notice before it ran out! Time to head to PP and renew.
 
Just realized I lost my silver star, I thought we'd get a notice before it ran out! Time to head to PP and renew.
thank you :)

You should have gotten an email warning, but they are commonly lost in the spam/junk folder...either running with the buy5/get6 or the subscription helps fix that ;)
 
A few from the weekend...6x10 "office" platform above the bathroom and slop sink area...just need a railing and steps :-)

One pic is standing on the platform, facing SE....the other is facing NW...

Yes, there are plenty of windows...and the entire W wall (concrete) will get a 4' wide walkway for crate/parts storage.

20160118_123534_wm.jpg
20160118_123455_wm.jpg
20160118_123131_wm.jpg


20160118_123534.jpg
 
I'm envious!
 
I see Bend Tech controls everywhere in that shop's future.

Foam or glass for insulation?
 
Foam or glass for insulation?
Insulation will be handled later, still unsure on interior finish. Want to be SURE the wiring is set first, so likely a year away. No heat going in, AC will be a swamp cooler (if needed, another "down the road" item) I'd like to get a year in before I close it up.

I'm now toying with putting most of the lighting on the walls....16' ceilings make any bulb changes a hassle...
 
Planning lighting tonight, looks like nine total 8' T8 fixtures on 4 switched banks at the ceiling level...should allow lighting specific areas easily, without breaking the bank. Just haven't found any LED's that are affordable...might do that for the "office" area tho.

Take a look here: LED Troffer

And a +1 on the Big Ass Fans.
 
I'm now toying with putting most of the lighting on the walls....16' ceilings make any bulb changes a hassle...

My T12HOs in my shop are over fifteen years old. LEDs would be even longer.
 

Users who are viewing this thread

Back
Top Bottom