Idle Problems

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

you could try there, clean it too, might be sticking or something
 
give some more info maybe have more replies,
like engine, carb, etc..
 
I took my 40 wheeling yesterday and after the excursion it will not idle at all. I must pull out the choke about 1/2 inch and it will idle then but as soon as I push it in, it dies. Any ideas?

Idle solenoid is not getting 12V + or the ground wire is bad.
 
If it happened "mysteriously" after wheeling, I would suggest giving everything under the hood a good look over and tighten. There are a lot of things that can work loose, vacuum lines, PCV, idle screw, lots of stuff.

Good luck, let us know what you find.

Rezarf <><
 
Back
Top Bottom