Hum/Vibration associated with clunk/ping?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 9, 2005
Threads
139
Messages
8,873
Location
Cedar Rapids, IA
1992 FJ80, 235k miles, 3FE motor. Just noticed a small ping/clunk when I was backing out of the gas station this morning. Didn't think too much of it. Then noticed it again when turning, going about 15 mph. U-joint? Then I noticed a steady, light vibration while going up to about 45-50 mph when it would go away. It felt and sounded like a "driving on pavement with a Mud Terrain tire" vibration and sound. Any ideas? Thanks.
 
Well it can't be the head gasket since it's a 3FE.
 
I guess I'm the first to have this issue?!
 
I'm thinking U-Joint also. They typically get above the hearing frequency at higher speeds. The noise and ping you describe are also consistent with this.

May want to check wheel bearings just in case.

Although, the head gasket may be the root cause! :flipoff2:
 
It's certainly not speed related, since the 3FE doesn't have the guts for it.
 
It's certainly not speed related, since the 3FE doesn't have the guts for it.

Wrong...just not uphill. Or on flat ground. Yes. I took this on a big down hill.
image.webp
 
Rock/bolt/rail road nail/etc, stuck in the tire?

Checked. All good on the tire front. No nails/screws/bolts. I hadn't thought of that. But it definitely feels driveline related. I can feel it in the steering wheel.
 
It's a 3FE so I'd immediately assume it's the owner. The mental faculties are obviously not there :flipoff2:

If this turns in to a 2 year thread and I can't find the problem and solve it (while spending $15k+) then and only then may you speak of my lack of mental faculties! :flipoff2:
 
It's certainly not speed related, since the 3FE doesn't have the guts for it.

Man, everyone is in a hurry. Not me. 75 mph suits me just fine. I like to enjoy the ride.
 
So, I haven't had time to check the U-Joints. Is this something I should just order the two kits and replace or should I bother checking them first? I won't have time to check them until Thursday night which is too late to get them in for this weekend.
 
Check them. Toyota U-joints set up by the factory is the longest lasting u-joint.

I'd also rule out engine because in a ~1200 lb rotating mass it is hard to have a vibration only at certain VEHICLE speeds, considering the 3FE's RPM range is very small it would be hard to get a vibration at only one RPM. Almost can guarantee it is a driveline anomaly.
 
Nothing else screams engine. She idles fine. No lack of power. Shifts right. I'll check the U joints Thursday night. I'm guessing I'm looking for some "play" in them. Any play is no bueno correct?
 
Correct. Also check all the pinion and transfer output flanges. There should be backlash, but no play axial to the vehicle.
 
Back
Top Bottom