Hub/rotor attachment?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

No benefit... They might come up missing and i was wondering about the NEED... If there would be a definite negative consequence from leaving them off.
 
numby said:
Oh krap, I knew that. I've been working on Dana front ends for the past few months. Sacrilege, I know:rolleyes:

I run a 60 under the front of my 40, the Red Truck.

Have not broken a Fing birfield since 1998.

:lol:
 
Digging up an old post once again since i was also disappointed with what i got in the mail. Went online and did some research.
Apparently, you can still get rotors for 60 series with 8 holes. but they are listed as superseded (replaced by 43512-60100).
Part Number: 43512-60040 for 8 holes (6 stud holes and 2 locating holes).
Part Number: 43512-60100 for 6 holes only. This part number superseded the previous. But both available at Toyota parts dealers.

I guess I am going to just install the 6 hole rotors. I honestly don't see the benefit and i guess Toyota didn't see either.
 
Back
Top Bottom