Hose issues

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 21, 2016
Threads
24
Messages
206
Location
Mt. P
I'm knuckle deep in this and while I continue to search, I figured I'd post for help.

Working on the coolant/heater hoses behind the engine. Got them all off but one, and I'd rather not have to go back in there later for it.

Need a little help as to what these actually run to and if I can just bypass one if not needed (rear heater maybe?) I'm just looking to get this completed. Sorry if this a dead horse topic, just causing me fits at the moment.

I can handle the part in my hand, just a reference for where I'm at. The other part still on the firewall is the one causing me problems. Would love to be able to bypass this area if at all possible while still retaining heat up front.

image.webp
 
This is the part/area in question. Ignore the new hose piece, it's just loosely in place.

image.webp
 
Not sure I entirely understand the question. But if I do, the part you are holding in your hand is the heater control valve. The metal tube in your second picture is the part that splits the coolant between the front and rear heaters. If you want to only have front heat, you can remove the metal tube, and only run from the top tube to the U to the heater control valve and then on the other side you would run from the heater tube above the engine to the top tube on the firewall. This will completely bypass the rear heater.
 
Yeah, my discription isn't the best. I finally got that last hose off, the lower one. I'm going to attempt to get it back the way it was with new clamps and hoses. Just beyond frustrating to work in that area.

I had originally thought it was my PHH until I dive into it earlier. Opening up a whole new can of worms that I hadn't researched yet. Hopefully I can get it buttoned up before long.
 
Yes, he was having issues getting to the lower hose:

"Need a little help as to what these actually run to and if I can just bypass one if not needed (rear heater maybe?) I'm just looking to get this completed. Sorry if this a dead horse topic, just causing me fits at the moment. "

So I told him how to bypass it like he asked. So yes don't do that if you want a rear heater.

It looks like that pic is with rear heater delete?
 
Well I got it a while back finally. Jebus, nobody should have to go through that to change a couple of hoses out :mad:

I think I compounded my frustration by going with Gates green strip. The stuff is simply not that flexible.

Appreciate the responses to my few minutes of venting :eek:
 
I did the same thing with napa's yellow stripe (same thing as the green stripe), and did not get to those two hoses. I figure if one or both fail, it will be time to pull the head off anyway.
 
Two of the best reasons to bypass the under seat heater, one, replacing those two rubber hoses above the cats is a real pain. Number 2, it's not uncommon for trucks out of the rust belt, to have rust problems with the steel tubing feeding the under seat heater too.
 
Back
Top Bottom