Hood Needs Adjustment

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

fjl40

SILVER Star
Joined
Dec 30, 2014
Threads
38
Messages
321
Location
Calabasas,CA / Mandeville, La
I was hoping to get some info on my situation. I did look at some other threads concerning this matter , but feel I need more information. Just for starters, this is an earlier model split hood on a 73'. It's been off road (the truck, not the hood) and had it's share of flexing. I put a new body mount kit on and hood bumpers on the bib. Also, I now have the rubber bumper between the bib mount and the frame. Didn't have that before. Not really worried about the fenders, I know how to adjust them. It seems the hood sits to high on the cowl. (If that is referred to as the cowl) The hinges are lose but I don't see how I can adjust this kind of gap. Looking for any miracles or a proper year hood, out there.

hood1.webp
 
How is the height between the body and hood, does one sit higher than the other? Are the rubber cushions between the hood and the hinge?
 
Have you verified that correct height body mounts are installed on the cowl?

Edit: this shouldn’t affect the diastance from hood corner to cowl but might change the slope?

I did notice a similar but not as pronounced gap on the ‘67 I’m working on is larger then on the 9/70 that I recently finished.
 
The apron and the tub would line up better if the A-pillar body mounts were slightly thicker. Same issue for the OP.

The front body mounts are supposed to be thicker at this location. Are you sure you have the correct thicker body mount bushings installed here?
 
I agree with the assessment that the A - pillar mounts are the likely culprit.

Loosen all the mounts and the bolts where the fenders attach to the tub, loosen the fenders where they attach to the frame, then lift the tub at A - pillars. My guess is the issue will go away.

This is a typical problem when incorrect body mounts are used, or the frame or A - pillar supports have sagged.

This was common issue back in the day when fender-well headers were used and guys cut through the A - pillar support to keep the exhaust out of harms way. It didn't take long for the support to sag. Tell tale sign was the hood sticking out over the bib.
 
I'm sure my body mounts are correct, fronts were labeled. But if I raise the front A - pillar mounts won't that just raise the hood the way it sits on the cowl? Here is a pic of the hood sitting on the bib. It seems since I now have the rubber cushion between the bib mount and frame, it's raised the hood. In the 2nd pic, it looks as the hood is being raised. By the way, thanks for all the input.

hood4.webp


hood3.webp
 
The pad/mount under the Bib should only be about 3/16". OEM is just webbing. How thick is yours?
 
Back
Top Bottom