Help with sensor that broke during removal

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 12, 2008
Threads
300
Messages
3,609
Location
West MI near GVSU
Website
www.mcdesignsoffroad.com
A399DE35-FF81-4945-BAED-8100578E1FB2.webp
I still don’t have a FSM and need help IDing a sensor from the block near the left rear.

1fze-1995
 
Knock sensor. If the tab is intact, you can likely epoxy the 'housing' back on. I successfully did that (a few yrs back) when I had a stupid moment doing the PHH.

cheers,
george.
 
Ok, thx. I’ll probably just replace it. It’s old and the engine is out-easy to replace.

Might as well replace both of them, if you have a spare ~$400 to blow. Personally if it was good, didn't code, would epoxy it.
 
Another alternative to $200 each. $215 for a pair to my door.

1fz knock sensor.webp
 
Dang. Been there. Done that.

Fortunately, I paid $28 each for genuine Toyota ones in December of 2016. I just checked on eBay and they are now $85 each.
 
So does anyone know if those same sensors were shared on other Toyotas, maybe some newer ones that could be found in a local wrecking yard?

They are tuned to the engine type, so unique to the 1FZ. There are others that will fit, but wont be correct.
 
Any recommendations of which epoxy to use?
Any ordinary non-conductive epoxy. The clears for consumers are non-conductive.
Just FYI I collect those knock sensors that Toyota uses whenever I see them in a boneyard. If they have the same thread and one terminal they will work just fine. The most I pay is $5 for them used.
 
jb weld is fine, that's what I used and it's been at least 6yrs that I epoxied my rear knock sensor back together again and no issues.

Just clean well first with a decent solvent to remove any grease/grime/oil etc where you will apply the epoxy. No need to overthink the repair...

cheers,
george.
 
I replaced one with a used one from ebay, the other with a new one from Rock Auto. Both worked. As mentioned above, the wrecking yard holds potential as a parts source for these.
 
Back
Top Bottom