Front bib rust

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 16, 2005
Threads
25
Messages
92
Location
Houston, TX
As I continue my build on my Spet. 74 built FJ40, I had a few parts sand blasted andnoted the rust on the front bib. TO the experts, is this worth saving and if it is what should I do? THe rust is limited to the bottom metal section and has not really eaten all the way through.

Any comments appreciated.

bib3large1sl.jpg
 
Fastest thing would be to find a clean one...but might not be cheap...


Matt(Buckroseau) repaired one in his 45 buildup thread.


That seems like more work than I would want to mess with....but it can be fixed.


Good luck!


-Steve
 
yes steve is right, easier to buy a better one, but it can be repaired, how good are you with metal?
 
Get yourself a spotweld cutter and seperate the inner channel from the bib. Use 16ga shhet metal and bend up a replica. On the front cut out the rust and patch. Use a weld through primer and reinstall the rear channel.

Took me a couple of hours to do but is much cheaper than a new bib.
 
I have the exact same problem on mine, although not as bad. I was planning on cutting it out and welding in a new seciton, but I'll probably replace that channel behind it also while I'm at it. I was going to cut out that section almost to the corners, then bend up a piece of steel angle to wrap around the bottom and weld it in. I didn't want to have to try and match those roundovers on the slots or sides, so I'll probalby leave a little bit of a lip so I just have to weld in flat pieces.
 
weld

I have never tried welding myself. I was thinking of grinding the potrusions down. Cut out the offending rust area with an air cut out tool. Then hope I can find someone to weld a piece of metal(s) over the holes. I have seen new fiber glass bibs but they are well over $200 bucks delivered. Thanks for your comments.
 
You can buy a new one from toyota for $300 and if you are a tlca member you can find a dealer that will give you 25% off (Champion Toyota Gulf Freeway is one I think) of that. I went through the same thing about two months ago, and I decided to trash my old one and pony up for the new one.
 
I've done a bunch of these, if you want to ship it to Odessa, I can do it for you.
 
I am sure you can get them new oem, I just bought a new oem one from toyota. I didn't buy from that dealership though, I just saw in Toyota Trails that they offered the 25% off for TLCA members. I know cruiserparts.net has them (no affiliation), but they are around 325 delivered. You could find a dealership for cheaper if you keep looking.
 
Mine was far worse that that. I just bent a few pieces of sheetmetal and cut the old stuff out and welded the patches in. A liberal coating of body filler, and it looks fine. They make these out of aluminum too. I plan on an aluminum one and an aluminum windshield frame in the future.
 
Back
Top Bottom