Found Vacuum Leak (s)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 24, 2019
Threads
8
Messages
21
Location
Idaho
This is my one month anniversary on Mud and as a first time owner of a 4/75 fj40. I’m in deep. I figure I can take this apart, but it may take longer to put back together. My progress so far - degreased the beast, removed top/doors/windshield/seats/hood/fenders/front bezel. My plan is to replace carburetor/fuel pump/distributor/coil/filters/4core radiator/ before body and paint. That said it runs rough and backfires through carburetor. Everything on here points to a vacuum leak. I hooked up a vacuum to the exhaust pipe and blew air into the system and sprayed soapy water. Found a lot of leaks. I am replacing the gasket, anything else I need? Thanks
6A148CA2-D6D1-426E-A417-5B3425D82206.webp


D1E5B5B2-5C2D-4FA0-991E-2BC9AB2FEA73.webp


72AFAA52-87E4-48BA-980D-4E32F41F3EF8.webp


AB420608-18F0-49F2-97DC-1CF788311677.webp


CDEC14D5-8B52-4492-B667-1F3DE7EFBF89.webp
 
Welcome to Mud! Where are you at in Idaho? Be sure to check in here:

I've never considered starting at the end of the system to diagnose a problem at the beginning of the system. Backfiring through the carb is more likely a timing issue than vacuum leak. Could be both. Did you do any other tests? Such as carb cleaner sprayed at the gasket edges (carb & manifold) while running? What did your vacuum gauge say?
 
I haven’t done any other tests yet. Next I’ll spray brake cleaner to see if it idles faster? Not sure where to hook up vacuum gauge. I’ll take all advice on how to proceed.
 
Yes, the idle goes up as it sucks in the fluid. You can hook it up to the brake booster if you have one. It just has to be direct vacuum from the intake manifold.

Here's some good info from the FAQs

FAQ - located at the top of the forum page.
 
Ok, timing is on the BB. I hooked up vacuum gauge to the manifold where the brake booster hose connects and it idles at 13.
 
Back
Top Bottom