FJ55 Tailgate manually raise or lower???

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 2, 2004
Threads
227
Messages
11,510
Location
Washington
All of a sudden my tailgate glass stopped working. It showed no signs of slowing just one day it worked then nothing. Is there any way to manually lower the glass so that I can put the tailgate down? I am going to take the tailgate off so that the body can be sandblasted and without lowering the glass I can't drop the tailgate. I know that the right thing to do would be to troubleshoot the problem now, but I would rather get the body done and troubleshoot later.

Thanks,
Ryan.
 
unfortunately there is no manual lower lever or anything, the only way i know to do it is to disconnect the regulator arms from the glass, once you open the access panel and follow the arms to the glass connection, you will see the "holders" that keeps it all together. once you look at it it'll make more sense
 
Probably just the position switch for the gate...Have someone push in on the gate while you operate the switch, and I bet it moves...



Rhino is right on...there is not a manual way to manipulate the window, other than taking the inner panel off...


Good luck!


-Steve
 
If you pull the panel try 12v at the 4 screw block .Bottom screw is the platelight next is Ground. top 2 are up and down.I use wires for cheaters so i can pull glass all the way down.But you can go down like 4" and pull the retainers to but there a SOB most times.I brake that dam window like once a year,guess i nead weather stripping,
 
You can try 1FE pig's suggestion AFTER YOU REMOVE THE GLASS! Too dangerous while the guillotine is still in place. :eek:
 
there was a NON US optional manual back window for the 55.....
 
I have had mine get stuck at the top several times. In most cases I had to crawl in the back, remove the tailgate panel and "help" it get started down. In a few cases a little manual help was all it needed to get started again, and once it was moving it would work again just fine. At least for a while. This really works just where the motor is weak or it is binding. In other cases, such as motor failure, this probably will not work.

You might try one of these

http://www.harborfreight.com/cpi/ctaf/Displayitem.taf?itemnumber=46134

to help get it moving.

The other thing to check is the motor ground. The motor grounds through a switch on the side of the tailgate-- designed to only provide a ground for the motor when the tailgate is up. In many cases the ground goes bad and really limits the power of the motor. That was the main problem with mine. I discovered the bad ground when I attached a wire with an alligator clip to give it "more ground" and the motor suddenly worked a ton faster.

Jared
 
Last edited:
Raising the dead. Here is more specificly what has happened. I have had my truck in the shop for a while and they lowered the glass to keep it from getting grind/metal on it. Now there is no battery and the glass is down. How do I get the window out so that I can remove the door for paint? It also looks like the handle is not working now as well. So if you have a picture of the inside of the tailgate, I would like to see what it looks like.

Thanks,
Ryan.
 
Back
Top Bottom