Ever "Heard" this?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 6, 2005
Threads
33
Messages
128
When I am driving my cruiser I hear a grinding noise almost like a clutch bearing, but when i put it under a load no noise. when rpm drops a little the noise comes back. When slowing down you hear it for just a second then it goes away. It only seems to happen at a certain rpm. Any ideas?
 
3 spd?
4 spd?
5 spd?
automatic?
FJ40?
Fj55?
Fj60?
Fj62,
Fj80?
Does this happen with the clutch in-out?
 
I have the exact same issue on my 74 FJ40. Word for word description of what 'rsnellie' put down. It's a 4 speed. Happens with clutch out (and not riding the pedal).
Also, I don't notice it as much in 2WD vs 4WD.
I was thinking X-fer case or maybe front diff?
 
Well I put in my guess since I have this same noise. I know what my problem is I just don't want to take the stupid transfer case off again to fix it.

My problem is the high speed gear bushing is worn out. Only happens when not under load. I noticed the slop at the time I rebuit the transfer case but didn't have the bushings. Another cause of a that noise would also be the idler shaft bearings being worn out or the idler shaft.

Sounds like a T-case rebuild is in your future. I've head they should be rebuilt every 60k miles. Though I doubt most go a lot longer with being rebuilt.

Also check your D-shaft for slop. Could also be a loose nut on the rear diff pinion.
 
Pilot bearing.

(as long as everyone is guessing without hearing, I will too :)
 
Idler gear bearing or bad U-joint or slip yoke. The pilot and throw out bearing don't run when the clutch is out. Check the magnet on the Tcase drain plug for metal chunks (not just powder) and check the drive shaft for slop. These would be sensitive to engine load and truck speed, but not necessarily a particular engine RPM.
 
well to the drive shaft guess... Thats a Negative. Lost the rear driveshaft and the noise was still there. It was there while in 2wd so im guessing based on that it's not the front driveshaft. Lets see if I can give a little more detail.
If I am driving and let off the gas with the clutch still engaged the noise comes and goes at a certain rpm... also by blipping the throttle a bit I can make it go away. At a stand still no noise reguardless of rpm. Same symptoms without the rear driveshaft in place and driving it with 4wd. Now if it was to be the transfer case wouldn't the noise have gone away if I lost the rear driveshaft? And if it were the front driveshaft under load causing the noise in the t-case would't being in 2wd get rid of the problem? Im thinking pilot also, but I guess now that the tub is off I might as well rebuild the t-case. I have never taken on a t-case myself and didn't really want to.
 
Trollhole said:
Sounds like a T-case rebuild is in your future. I've head they should be rebuilt every 60k miles. Though I doubt most go a lot longer with being rebuilt.
If you drill and tap the fill level bungs in the T-case and gearbox and run a connecting hose this stops the T-case pumping all its oil into the gearbox and running itself dry. This prolongs the life of the T-case by a massive amount.
 
desertboy said:
well i'm thinking input bearing on the tranny, does the noise go away in 4wd? from the brief description it's a bearing of some sort not a u-joint my 2cents which aint worth a nickel :D


Input shaft bearing got's my vote
 
Back
Top Bottom