Electrical gremlin

[SmokingRocks]

You can test for power at EA1.

That may be easier to access.

 

[sea bass]

You can test for power at EA1.

That may be easier to access.

I already did that I do have power going in and out of EA one

 

[sea bass]

My question is where does it go after ea1

 

[SmokingRocks]

to J1 behind the cluster as seen in the page that another user referenced.

 

[SmokingRocks]

I doubt this is where your problem is. I suspect a bad ground.

Is your rig a 93-4 or later? The FSM's available for free download on this site have all the EWD's you need.

 

[sea bass]

Bingo found it there was a three-way splice like this one from the factory inside the harness right before it goes into the firewall grommet

 

[sea bass]

Thank you to everyone who chimed in and helped now to get it all wrapped up and back together

 

[sea bass]

Just to let people know I found quite a few of little splices come in from the ea1 harness these splices were from the factory covered with little blue tape,one wire going to three wires

 

[landcrshr]

Great job! So are the dome lights all working now?

And the Ignition circuit?

 

[sea bass]

Everything is working as it should dome lights radio clock all is well in 80 world life is good dash is back together, all of that Dash plastic is sure getting fragile

 

[sea bass]

It looks like water got down into that electrical tape in the harness throughout the years and eroded away the splice

 

[SmokingRocks]

Nice good work.